Inhaltsverzeichnis
Werbung
•
No staples at the end of the jaws:
⇒ Check the contents of the loader;
⇒ Check air supply and service pressure.
⇒ Use once without stapling anything and check the closure of previous staple. In fact
in the operation of the device, an incomplete closure means that the staple-set knife
doesn't fully go backward;
•
Last staple is not taken:
If for whatever reason (the device falls for example) the staple-pusher unit is not perfectly
aligned with the loader, i. e. slider is no longer parallel to the loader , this problem can
arise. To resolve the problem realign the 2 parts.
•
Staples does not close properly:
Check that jaws' mounting-screws are tightened correctly (screws + nuts (Nyloc nut) with
washers).
Note: When disassembling / reassembling, put Loctite 243 on the screws.
When disassembling the staple thrust, bring the knife back completely before putting the
latter into place.
The wear and tear parts are:
REPAIR KITS: Seals repair kit:
AerSeat tools: kit code number 83575
1 cover seal, code number 78033
2 front seals, code number 89845
1 piston seal, code number 81406
1 piston's rod seal, code number 105981
AERSEAT (indice AF) – 18/09/2017
BREAKDOWNS
WEAR AND TEAR PARTS
23
Werbung
Inhaltsverzeichnis
