Signing On/Off The Remote Control - Miele DARC 6 Gebrauchsanweisung

en - Signing on/off the remote control
The remote control must be signed on
so that it can be used.
Signing on and off must be done at the
same time on the cooker hood and the
remote control. Signing on/off mode
has to be accessed on the cooker hood
first, then on the remote control.
To access signing on/off mode on the
cooker hood
 Press the fan run-on button 515 for
approx. 10 s until the indicator for
power level 1 lights up.
 Then press in turn:
– the "" control (1 sensor)*,
– then the "" control (IS/B sensor)*,
– then the lighting control .
 Then access the Signing on/off mode
on the remote control immediately.
To access signing on/off mode on the
remote control
 Press and hold both arrow buttons
 at the same time for approx. 5
seconds until the remote control LED
flashes.
 Press the lighting button .
18
To start the signing on procedure
 In Signing on/off mode press the ""
control (IS/B sensor)* on the cooker
hood first.
On DA xxx8 model cooker hoods: wait
until 2 and 3 light up continuously and
B flashes.
 Press the "" button on the remote
control.
The search for a wireless connection
will start. The remote control LED
flashes regularly.
After approx. 30 seconds, the remote
control LED flashes on and off four
times with short intervals between the
flashes. The wireless connection has
now been established. The LED will go
out after a short while.
 Confirm the signing on procedure by
pressing the 515 run-on control on
the cooker hood. All the indicator
lights will go out.
The remote control can now be used.
If confirmation is not carried out within
4 minutes, activation will not take place.
To cancel the signing on procedure
 If it is not possible to sign on, the
procedure can be cancelled by
pressing the 515 run-on option
control on the cooker hood and on
the remote control.
 The signing-on procedure must then
be repeated. To do this the cooker
hood and the remote control must
first be signed off.