Installation; Maintenance - SuperFish PondECO Plus E3500 Gebrauchsanweisung

Installation

• Cut the hose connector to the desired diameter and fasten this to the pump.
• Connect the pond hose to the hose connector using a hose clamp (not supplied).
• Install the pump in your pond at least 20 cm below the surface of the water. Make sure
that the pump is seated firmly.
• When used inline, outside of the pond; make sure the pump gets enough water supply
and does not run dry, make sure all connections are 100% waterproof, leakage may lead
to an empty pond and cause harm to your fish and plants.
• Never lift the pump out of the water by pulling the power cord.

Maintenance

• Remove the pump from your pond during frosty periods and clean it well and store it in
a dry place free from frost.
• Your pump needs regular cleaning, see page 10, there is no warranty on failures due to
dirty pumps and scale build up inside the pump caused by improper maintenance.
• Depending on usage the rotor of your pump can get worn out and damaged, this is
normal, new rotors can be purchased at your dealer.
• Damage of cable, rotor or other parts due to wrong usage, is not covered by warranty!
7
6
5
4
3
2
1
0 1
2 3
PondECO Plus E
Voltage
Power
Capacity
Max. head of water
Connection
Cable length
4 5 6 7 8
3500 5000
14 W 22 W
3,500 l/h 5,000 l/h
2.00 m 3.00 m
10 m 10 m
9 10 11 12
8000 10000
220-240 V/50 Hz
41 W 68 W
7,800 l/h 9,200 l/h
4.20 m 5.80 m
40/32/25 mm
10 m 10 m
PondECO Plus E 20000
PondECO Plus E 15000
PondECO Plus E 12000
PondECO Plus E 10000
PondECO Plus E 8000
PondECO Plus E 5000
PondECO Plus E 3500
13 14 15 16 17
12000 15000
85 W 130 W
11,200 l/h 15,000 l/h
6.00 m 6.50 m
50/40 mm
10 m 10 m
18 19 20
Capacity
20000
150 W
19,500 l/h
6.00
10 m
3