Machine-Specific Safety Warnings - Scheppach MJ180 Originalbetriebsanleitung

Introduction
MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
89335 Ichenhausen
Germany
DEAR CUSTOMER,
We hope your new tool brings you much enjoyment
and success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling,
• Non­compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non­original spare
parts,
• Application other than specified,
Unpacking
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, store the packaging until the warranty
period has expired.
ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
Description (Fig. A)
1. Moving jaw
2. Fixed jaw
3. Main body
4. Lock/unlock switch
5. Foot pedal
6. Foot pedal lock
7. Front legs
8. Front leg locks
9. Front leg lock indicators
10. Front foot
11. Rubber anti-slip pad
12. Rear leg
13. Rear leg lock lever
14. Front carry handle
15. Rear carry handle
16. Rear stability foot

Machine-Specific safety Warnings

m
Please read the safety instructions! These in-
structions will make it easier for you to handle the
device and help prevent misunderstanding and pos-
sible damage or injury.
1. Keep your work area tidy and well lit.
2. Keep children and spectators away. Do not allow
people not involved to remain inside the work area.
3. Make sure that all moveable parts can move freely.
4. Wear appropriate work clothes. Do not wear loose
clothing that can become entangled in moveable
parts.
5. Use personal protective equipment such as pro-
tective goggles, hearing protection and protective
gloves. Always use breathing protection when work-
ing in a dusty environment.
6. Make sure that all fastening screws and buttons are
screwed tight and that the legs are clicked into place
and secured before starting the device.
7. Make sure that the device is stable on a firm, even
floor.
8. Ensure its balance. If large workpieces are cut from
one end, the remaining piece may be heavy enough
to topple the device. Always make sure that the
workpiece is secured.
9. Do not stand on the device.
10. Only use the device for its intended purpose. Any
use not listed in these operating instructions is
deemed improper use. The manufacturer does not
assume liability for damage or injuries caused by
improper use.
11. Use of accessories not mentioned in these operat-
ing instructions can lead to injuries.
11 І 32