Service; Disposal / Environmental Protection - Rosenbauer FANERGY Anleitung

Rosenbauer – FANERGY
cannot be sucked into the fan housing. Secure the belt end against suction
on the opened grab handle or frame of the fan.
▪
The proportioner can be coupled between the connecting coupling on the
device or between the water supply.
▪
The hoses to the water supply have to be routed from the back to the fan.
▪
Due to the very high air output and when using a multipurpose foaming
agent, a foam expansion of 1:500 to 1:800 is achieved.
▪
As a result, at-risk objects, such as basement rooms, hazardous materials
storage, etc. can be flooded with expansion foam in a short amount of time.
▪
Note: After every operation of the FANERGY fans as a high-expansion foam
generator, all parts which have come in contact with foam must be rinsed
with clear water. To do this, as a primary cleaning measure disconnect the
foaming agent supply and generate a water spray with the fan. Then remove
the foam net. Should there be remainders of foaming agent, rinse off with a
soft water stream after the propulsion unit has cooled off.
6

SERVICE

▪
Please observe the instructions in the motor operating manual for models
with a combustion motor.
▪
No special service activities are necessary for models with an electric motor.
7

DISPOSAL / ENVIRONMENTAL PROTECTION

After repairs or use please dispose of any leftover materials and used parts in
a responsible, environmentally-friendly way.
Oils:
Rubber and plastic parts: Please observe local waste disposal regulations
Metal parts:
Fuel:
Battery/Battery acid:
28
Please observe local waste disposal regulations
Please observe local waste disposal regulations
Please observe local waste disposal regulations
Please observe local waste disposal regulations