Radio Operation - auna Verticalo DAB Bedienungsanleitung

OPERATING INSTRUCTIONS
Getting started
1. Turn on the unit: press the POWER button (on the back of the unit) to
pos."I", and then press the STANDBY button at the front panel. "Power
On" will be shown on the screen.
2. Turn off the unit: press the POWER button (on the back of the unit) to
pos."O".
Note: to help save power consumption, if there is no audio signal input
for about 20 minutes while the unit is powered on, the unit will power off
automatically. To turn power back on and resume playing, you will need to
turn off the power first, after 5 seconds turn it back on to continue.
PHONO OPERATION
1. Turn on the unit.
2. Press the MODE button to select the PHONO mode. "PHONO"will be
shown on the screen.
3. Rotate the SPEED CONTROL KNOB(on the back of the unit) to the
correct speed (33 1/3, 45 or 78 rpm) for the select record.
4. Take out the MAGNETIC ADAPTER, put a record on the TURNTABLE
lightly, then put the MAGNETIC ADAPTER back to fix the record.
5. Move the tone arm over the record and lower it to point from which you
want the record to start.
6. Rotate the volume control knob to get desired sound level.
7. At the end of the record, the tone arm will stop automatically.
NOTE: Do not turn or stop the turntable manually. Moving or jarring the
turntable without securing the tone arm clamp could result in damage to
the tonearm.

RADIO OPERATION

1. Turn on the unit.
2. Press the MODE button to select the FM mode. "FM" will be shown on
the screen.
EN
17