Clatronic HMS 2739 Bedienungsanleitung Seite 29

5....-05-HMS 2739
This is for switching to maximum speed for a short time. Press at short intervals for
pulsed mode operation.
WARNING! Do not use this function for more than one minute!
1. Turn the power level selector switch (3) to "0/AUS" and ensure that the mixer (1)
has been disconnected from the mains.
2. On the back of the mixer push the cover of the installation aperture upwards.
3. Place the fast mixing rod on the installation aperture in such a way that the two
arrows are pointing one above the other. To lock the rod in place, turn it through
approximately 90° in a clockwise direction.
4. Insert the mains plug into a properly installed 230V/50 Hz safety power socket.
5. Place the fast mixing rod into a high-walled, partly-filled vessel.
Caution! Do not operate the fast mixing rod when the vessel is empty, i.e. when
there is no food in the vessel to be mixed.
6. Select a speed using the power level selector switch (3). Move the fast mixing
rod slightly up and down.
7. When you would like to stop mixing, turn the power level selector switch to "0"
and unplug the device from the mains.
How to use the Kneader hooks/beater
1. Turn the power level selector switch (3) to "0/AUS" and ensure that the mixer (1)
has been disconnected from the mains.
2. Press the end of the kneader hooks/beater (10) into the corresponding mixer
openings until the hooks click into place. While pressing, turn slightly in order to
facilitate the whole operation. Please note that the kneading hook with the cur-
ved washer on the shaft can only be inserted on the left-hand side of the mixer
when viewed from the bottom.
3. Insert the mains plug into a properly installed 230V/50 Hz safety power socket.
4. The handmixer (1) can be used at various speeds set with the speed regulator
(3).
5. In order to release the kneading hook/whisk (10) turn the power level selector
switch to "0/AUS" and ensure that the mixer has been disconnected from the
mains.
6. Press the button (2) to release the kneading hook/whisk. Remove the device by
turning it slightly.
Please select a flat non-slip surface for the mixer stand.
1. Place the hand mixer (1) on the upper section (5) of the mixer stand (4). Please
check whether the clip (12) of the upper section is locked in place on the back
of the mixer.
25.04.2003 10:26 Uhr
Turbo operation
How to use the Blender
How to use the Mixer stand
Seite 29
29
GB