Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning The Housing - PICO WPS600C Benutzerhandbuch

Vorschau ausblenden Andere Handbücher für WPS600C:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

WPS600C

Cleaning the housing

Clean the transducer's housing by wiping it with a cloth moistened with clean water or
water-based detergent. Allow the housing to dry before use.
Do not use fuel or any other solvent
Do not use abrasive cleaning agents
Do not submerge the unit in any liquid
Do not dismantle the unit
Do not use the unit until it is completely dry
Recharging the internal battery
To charge using a computer, switch on the computer and allow it to boot. Disable
any power-saving modes to ensure that the computer does not switch off before
recharging is complete. Connect the transducer to the USB port of the computer with
the USB charging cable provided.
To charge using a USB wall charger, connect the transducer to the charger with the
USB charging cable provided.
Leave the transducer to charge for 5 hours.
CAUTION:
Use ONLY pressure hoses specifically designed for high-pressure testing. Pico Technology
cannot accept responsibility for damage or injury caused by the use of unsuitable or
damaged pressure hoses or adaptors.
Unplug the USB charging cable from the transducer before use. Leaving the cable
plugged in may affect measurement accuracy.
The battery inside the WPS600C is designed to give a long service life and is not user-
replaceable.
Repairs
If the unit is damaged or stops working, or the battery is not charging or holding
charge, return it to Pico Technology or an authorized Pico distributor for repair. Do not
attempt to dismantle or repair the unit yourself.
Disposal
The WPS600C contains a lithium polymer (LiPo) battery. If the battery has reached the
end of its life, you may return the unit for repair. When the transducer reaches the end
of its life, take the entire unit to a battery recycling facility for safe disposal.
YOU MUST observe the instructions below. Incorrect disposal of the battery could
cause a fire or an explosion.
Do not open the unit to remove the battery
Do not crush or shred the unit
Do not dispose of in fire
4
Pico Technology
DO187-9

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis