Front-Panel Controls; Preparation For Use; Before First Use; Using The Wps600C - PICO WPS600C Benutzerhandbuch

WPS600C
1.3

Front-panel controls

Signal output to oscilloscope
USB charging port
Signal output
USB charging port
Inlet port
1.4

Preparation for use

Before first use

• Remove all packaging.
• Charge the internal battery. For instructions, see section 1.6 Maintenance.
1.5

Using the WPS600C

Prepare the transducer
• Make sure that the transducer's internal battery is charged.
• Unplug the charging cable from the transducer.
• Turn the transducer on.
• The 600 BAR LED will light up to show that the unit is ready.
2
Use the BNC-to-BNC cable supplied to connect this to your
oscilloscope.
CAUTION: This connector is plastic mounted to ensure
measurement accuracy. It could be damaged by a strong impact.
For battery recharging only (no data connection). Connect to any
USB port on a computer or wall charger.
Do not operate the unit with the charging cable connected as
measurement errors may occur.
M16 x 2 Minimess connector that can be connected to a suitable
test port or to an appropriate high-pressure hose.
Front-panel controls
Pico Technology
Inlet port
DO187-9