Safety Instructions And Liability; Eu Declaration Of Conformity - Lamello Profi la Pro plus Bedienungsanleitung

Safety instructions and liability

Please also read the enclosed general safety instructions carefully before putting your machine into
service.
- Compressed air can cause serious injuries
- After use always close the air supply, let the remaining compressed air discharge from the hose and then
disconnect the tool from the air supply. The same procedure applies when accessories are changed or repairs are
undertaken
- Never direct compressed air onto a person
- Lose pressurized hoses can cause injuries. Always check the tool for lose and damaged hoses and adapters and
repair them immediatly if necessary
- Do not set the maximum air pressure higher than 6.2 bar ( 90psi)
- Clamp work tightly if possible and guide machine with both hands
- Only use tools which are approved for tool speed (22'000 min-1)
- Use sharp tools only
- Do not stop the cutter after switching off the machine
- Rotating cutters are dangerous and can cause serious injuries or material damages. Never touch the rotating
cutter
- Keep clothes and hair away from the rotating parts
- Flying splinters can injure the eyes. Use protection goggles while working.
- Manufacturer and retailer disclaim all product liability if the machine is modified in any way from its original state
or condition as delivered, or if the grooving machine is used in a manner inconsistent with operating and safety
instructions.
EU-Declaration of Conformity
We declare under our sole responsibility that this product is in conformity with the following standards or normative
documents:
EN 55014, EN 60745-1, EN 61000 in accordance with the re gu lations of directives
73/23EWG, 98/37/EG, 89/336/EWG.
Sound emission and vibration acceleration
Typically A-weighted noise levels of the tool are:
Sound pressure level = 78 dB (A)
Sound power level = 90 dB (A)
Wear ear protection!
Typically the hand-arm vibration is below 2.5 m/s
Lamello AG
Holzverbindungstechnik
Hauptstrasse 149
CH-4416 Bubendorf
Lamello AG: Sitz Bubendorf, Gerichtsstand Liestal
Haftende Gesellschafterin: Lamello AG, Sitz Bubendorf, Gerichtsstand Liestal
Geschäftsführer: Herr Karl Steiner, stellv.: Herr Erich Zeller
.
2
K. Steiner
English
E.Zeller
11