SENTAR sp31105 Bedienungsanleitung Seite 9

ASSEMBLY OF HOPPING BAG
1. (Figure 10) Turn a rear hopper tube so that the brace holes in the middle of the tube face down.
Slide the tube through the two loops sewn to the top rear seam inside the hopper bag.
REAR HOPPER TUBE
(brace holes on bottom)
2. (Figure 11) Insert the two upper hopper side tubes through the stitched flaps on each side of the
hopper bag.
3. (Figure 11) Assemble the ends of the rear hopper tube onto the ends of the upper hopper side
tubes.
4. (Figure 12) Turn the second rear hopper tube so that the brace holes in the middle of the tube
face up. Assemble the ends of the rear hopper tube onto the ends of the lower hopper side tubes.
Fasten together using plastic plugs.
10
INNER BAG LOOPS
REAR HOPPER TUBE
PLASTIC PLUG
(brace holes on top)
LOWER HOPPER
SIDE TUBE
PLASTIC PLUG
UPPER HOPPER
SIDE TUBE
12
11
UK
9