SENTAR sp31105 Bedienungsanleitung Seite 5

ASSEMBLY
REMOVE THE HARDWARE PACK AND ALL LOOSE PARTS FROM THE CARTON AND VERIFY THAT
ALL THE PARTS AND FASTERNERS SHOWN ON THE LAST PAGE ARE INCLUDED.
ASSEMBLY OF SWEEPER
Note: Right hand (R.H.) and left hand (L.H.) are determined from the operators' position while seated
on the Tractor.
1. (Figure 1) Assemble the angle bracket to the sweeper housing using a M8x16 hex bolt and a M8
hex lock nut. Make sure the bracket is turned as shown and aligned straight with the housing and
then tighten.
3. (Figure 2) Assemble the R.H Hitch Tube to the sweeper housing using M6x35 Hex Bolt and M6
Lock Nut. Do not tighten yet. Repeat for the L.H hitch tube.
M8 HEX
LOCK NUT
M6X40
HEX BOLT
M6 HEX
LOCK NUT
1
ANGLE
BRACKET
M8X16
HEX BOLT
2
UK
5