SENTAR sp31105 Bedienungsanleitung Seite 11

10. (Figure 16) Tip the hopper onto it's back to assemble the two hopper support rods. Place the
ends of each rod into the upper and lower rear hopper tubes bending the rod just enough to fit into
the holes in the tubes.
11. (Figure 17) Feel along the stitched flap on the hopper bag to locate the lower hole in each
upper hopper side tube. Place a hole through both sides of the stitched flaps in alignment with the
lower hole.
12. (Figure 18) Insert a Ø8X59.5 clevis pin through the lower hole in each upper hopper side tube.
Next assemble a bag arm tube onto each clevis pin and secure it with a hair cotter pin Ø3.
17
Ø3 HAIR
COTTER PIN
Ø8X59.5
CLEVIS PIN
LOWER HOLE
BAG ARM
TUBE
16
18
VINYL CAP
UK
11