Storage & Transport; Disposal And Recycling; Troubleshooting - Scheppach HTH250 Originalanleitung

• Clean the cutting device on a regular basis using a
brush or a cloth. Never clean the knives with water
(Risk of corrosion!)
• Clean and oil all moving parts regularly.
• Never use any grease!
• Use for instance environmentally acceptable spray
oil.
Maintenance schedule
Operation - Maintenance interval
Adjust the cutting device If required
Adjust the idle speed If required
Tighten the silencer screws If required
Clean/replace the fuel filter. If required
Clean/replace the air filter Every 8 hours of operation
(more frequent in case of
dusty environments)
Lubricate the gearbox Every 20 hours of operation,
at least once in a year
11. Storage & Transport
Storage
Store unused devices with attached protective cover in
a dry, locked place out of the reach of children.
To extend the service life of the hedge trimmer and
guarantee smooth operation, before storing for a longer
period.
Thoroughly clean the device.
Treat all movable parts with an environmentally friendly.
oil.

13. Troubleshooting

Fault
Hedge trimmer does not work.
Hedge trimmer cuts with interruptions
Engine is running, cutting device does
not move
Cutting device gets hot
Never use any grease!
Slide the protective cover on the cutting device.
Remove the spark plug connector.
Empty the fuel tank completely.
Dispose of remaining fuel in an environmentally compa-
tible manner.
Operate the engine until the carburettor is empty.
Transport
To transport the device stop the engine and wait until
the cutting device does not longer move. Attach the
protective cover.
Carry the device with the front handle.
When transporting the device within a car put it in the
boot or on a separate loading area. Secure the hedge
trimmer against tipping over, damages and fuel spilla-
ge.

12. Disposal and recycling

The disposal instructions are based on icons placed on
the appliance or its package.
The package protects the appliance against damage
during transport. Packing materials are usually chosen
depending on their environmental friendliness and dis-
posal method and can therefore be recycled. Returning
the package to material circulation saves raw materials
and reduces waste disposal costs.
Parts of packages (e.g. foils, styropor®) can be
dangerous to children.Risk of suffocation!
Keep parts of packages away from children and dispo-
se them as soon as possible.
Possible cause
• No fuel supply
• Fault in the fuel line
• Fuel filter clogged
• Spark plug defective
• Carburettor defective
• Internal fault.
• Internal fault.
• ON / OFF switch defective.
• Cutting device blocked
• Internal fault.
• Clutch defective
• Missing lubrication => friction
• Not enough play
• Cutting blades are blunt
Remedy
• Check the fuel quantity
• Check the fuel line for kinks or damages
• Clean/replace the fuel filter
• Replace the spark plug
• Manufacturer or responsible customer
service must be called
• Manufacturer or responsible customer
service must be called
• Manufacturer or responsible customer
service must be called
• Manufacturer or responsible customer
service must be called
• Remove object
• Manufacturer or responsible customer
service must be called
• Manufacturer or responsible customer
service must be called
• Oil the cutting device
• Adjust the sliding play
• Have the cutting device sharpened
GB 27