Werbung
Verfügbare Sprachen
Verfügbare Sprachen
S3250
Warning
9.
Read this manual before operating tool. It is the responsibility of the employer to place the
information in this manual into the hands of the operator. Failure to observe following
warnings could result in injury.
10. This tool shall not be used in potentially explosive atmospheres.
11. Disconnect the air hose before changing or adjusting any inserted tools.
12. Don't wear loose or baggy clothing when you operate the air tool. Remove anything that
may be caused injury, i.e. neckties, jewelry etc. Tie back long hair and wear eye
protection.
13. Keep your body in well balanced position and always wear gloves to reduce the risk of
crushing caused by torque between handle and work-piece.
14. Always turn off the air supply and disconnect the air supply hose before installing,
removing or adjusting any accessory on this tool, or before performing any maintenance
on this tool.
15. Never point an air tool at oneself or any other person. It could cause serious injury.
16. Keep all nuts, bolts and screws tight and ensure equipment is in safe working condition.
Specification
Air Impact Wrench
Impact Mechanism
Square Driver
Max. Torque
Free Speed
Air Consumption
Hose Size
Air Inlet
Weight
Length
SW-Stahl und Werkzeugvertriebs GmbH
Leverkuser Strasse 65
D-42897 Remscheid
S3250
Twin Hammer
12,5 mm (1/2")
800 FT-LB
7000 R.P.M.
7.4 CFM
3/8"
1/4"
5.5 LBS
6-1/2"
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
www.swstahl.de
Werbung
