Maintenance - wehncke 12193 Benutzerhandbuch

Temperature key
Key for setting temperature. Press this key and the numbers on the display screen will start
flashing, and the keys for increasing or decreasing temperatures can be pressed to set the
temperature. When settings are finished, press the TEMPERATURE key again to confirm. De-
fault temperature is 40°C, and the temperature can be set in the range of 20-42°C.
key for increasing temperature
key for decreasing temperature
Base of the controller is made of environmental-friendly PU material. Surface of the base
can be washed.
Filling and maintaining of whirlpool
Water should be filled to a position 20 mm higher than the water line. If lower, heating may
not be realized. If higher, water may spill over the tank in use.
Water in the water tank body should be filtered at fixed time regularly. It is not suggested to
filter the water at all times.
Water in the water tank body should be treated with chemical agents periodically. However,
chemical agents with calcium ions must not be used. If chemical agents with calcium ions
are used for water treatment, there will be very likely to form scales on the walls of water tank
and inner heating pipes. Water scales will directly damage the inner electrical components
inside the control cabinet and further affect the service life of control cabinet.
If the filtration system has worked for 168 hours, the system will emit a warning tone to remind
the user to clean or replace the filter element.
Drain off the water inside the water tank completely and wipe off droplets of water on the
walls. After that, lay aside the whirlpool for 24 hours, exhaust the air and fold. If it is cold, e.g.
below 10°C, fold the whirlpool indoors only because material may become hard and can
easily break when being folded. Put the pool into original box and store it at a shaded and
frost-free place.

Maintenance

A. Maintaining water
1. Clean your filter cartridge at least once a time after it worked continuously for 72-120
hours. The filter cartridge should be replaced at least once a month depending on use.
2. Change water every few days or use appropriate pool chemicals. All pools require the
use of pool chemicals. Please consult your local pool supply retailer for more information
about chemical maintenance. Pay close attention to the chemical manufacturer's in-
structions. Pool damage resulting from misuse of chemicals and mismanagement of pool
water is not covered by the guarantee.
a) Water balances we recommend maintain your water pH between 7.2 and 7.8, total al-
kalinity between 80 and 120 ppm and free chlorine between 3 to 5 ppm. Purchase a test
kit to test your water chemistry before each use of the pool, no less than once per week.
Low pH will damage to the pool and pump.
b) Water sanitation is the responsibility of the pool owner, achieved through the regular and
periodic (daily, if necessary) addition of an approved sanitizer. The sanitizer will chemi-
cally control the bacteria and viruses present in the fill water or introduced during use of
the pool.
23