Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TROUBLE SHOOTING
SYMPTOMS
NO SOUND
AMP NOT
SWITCHING ON
NO SIGNAL
ON ONE CHANNEL
AMP TURNING
OFF
MEDIUM / HIGH
VOLUME
PROTECTION
LAMP ON
Soundstream Distribution:
Audio Design GmbH · www.audiodesign.de
16
Am Breilingsweg 3 · D-76709 Kronau (Germany)
Tel. +49 (0)7253 - 9465-0 · Fax +49 (0)7253 - 946510
CHECK
Is the power
LED illuminated?
(NO)
Is the Diagnostic
LED illuminated? (YES)
No power to power wire
No power to remote
wire with receiver on
Burnt or broken fuse
Check Speaker Leads
Check Audio Leads
Check Speaker load
impedance
Shut down
Speaker wires shorted
REMEDY
Check all fuses to amplifier.
Be sure Turn-on lead is connected
check signal leads.
Check gain control.
Check Tuner/Deck volume level.
Clean contacts on fuse holders.
Check for speaker short or
amplifier overheating.
Repair power wire or connections.
Check connections to radio.
Replace fuse
Inspect for short circuit or an
open connection.
Reverse Left and Right RCA inputs
to determine if the problem is
occurring before the amp.
Be sure proper speaker load
impedance recommendations
are observed.
(If you use an ohmmeter to check
speaker resistance, please
remember that DC resistance and
AC impedance may not be the same.)
Turn radio down
Wait for AMP to cool
Separate speaker wires and insulate
D E S I G N
Werbung
Inhaltsverzeichnis
Fehlerbehebung
