Controls & Functions - Audio Design SoundStream xxx-6500 Bedienungsanleitung

LINEOUT
L
R
1
1
Low Level OUT RCA Jacks
The LINE OUT allows you to build multiple amplifier systems without having to use splitter cords to distribute
the signal. Now it is simply a matter of bringing one set of RCAS into the first amplifier, then using the
line out RCA jacks as the feed to the next amplifier.
2 2
Low Level INPUT RCA Jacks Low Level INPUT RCA Jacks
These inputs are for signal cables from the source. Always use high quality shielded RCA
cables. This control allows you to vary the amplifier's input sensitivity between 0.5 (500
millivolts) and 10 volts.
3
Input Sensitivity Adjustment
Clockwise (right-side) rotation raises the threshold and lowers the sensitivity, requiring higher input signal
voltage from the source, in order to obtain maximum output. counterclockwise (left-side) adjustment
lowers the threshold and raises the sensitivity, requiring a lower source voltage from the headunit. The
overall objective is to set this control to some intermediate point (0.5 - 10 volts), which closely matches
the voltage produced by the head unit. Avoid setting the threshold too low and supplying excessive
input signal voltage, as this would saturate the input stages and introduce unwanted distortion.
SUB BASS
LINE IN
LEVEL
SONIC BOOST
Min Max 15Hz 40Hz 0 +18dB
2 3 4 5
POWER GROUND
11 12
LINEOUT LINE IN
L
R
LINEOUT LINEOUT LINE IN
L L
R R
Min
CONTROLS & FUNCTIONS
BRIDGED MODE
REMOTE LOW PHASE
PASS SHIFT
SLAVE MASTER
50Hz 150Hz 0° 180°
6 7 8
SPEAKER
REMOTE
13 14
LEVEL
Max
POWER
PROTECTION
DATA LINK
9 10
11