Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10
LED Indicator
POWER: This GREEN LED will illuminate when the amplifier is turned "ON". If it fails to illuminate, check the
power connections to the amplifier.
PROTECT: The amplifier protection circuitry will disable the amplifier if input overload, short circuit or
extremely high temperature conditions are detected. When the protection mode is in operation, the
red LED indicator on the side panel will be illuminated, indicating the amplifier has gone into a self-
preservation mode.
If you observe that the Protection LED is lit, please check the system carefully to determine what has
caused the protection circuit to engage. The amplifier can be reset by turning the remote power off
and then on again. If the amplifier shut down due to a thermal overload condition, please allow it to
cool down before restarting. If the amplifier shut down because of an input overload or short circuit, be
sure to repair these conditions before attempting to power up the amplifier again.
11
2 Power (Battery positive)
Due to the power requirements of the Amplifier, this connection should be made directly to the positive
(+) terminal of battery. For safety measure, install an in-line fuse Holder (not included) as close to the
battery positive( +) terminal as possible with an ampere rating not to exceed the maximum current
specified on page 10. To avoid unwanted ignition noise caused by ground loops, it is essential that the
Amplifier be grounded to a clean, bare, metal surface of the vehicles chassis.
Note: GROUND WIRE SHOULD NOT BE EXTENDED MORE THAN 3 FT (1 METER).
13
2 Remote Power On
To remote wire From car stereo.
The amplifier is turned "ON" remotely when vehicle's stereo is turned "ON"
Note: IF YOUR RADIO DOES NOT HAVE + 12 VOLT OUTPUT LEAD WHEN TURNED ON, THE "REMOTE" TERMINAL
ON THE AMPLIFIER CAN BE CONNECTED TO VEHICLES ACCESSORY CIRCUIT WHICH PROVIDES + 12V WHEN
THE CAR IS ON.
14
Speaker Terminals
MONO MODE Wiring Diagram
Use only sufficient speaker cables to connect the subwoofer with the speaker outputs of the amplifier.
Please observe speaker channel and polarity as printed to avoid incorrect phasing.
POWER
PROTECTION
POWER
GROUND
REMOTE
SPEAKER
SUBWOOFER
1 OHM
12
2 B-Terminal (Chassis Ground)
13
Werbung
Inhaltsverzeichnis
Fehlerbehebung
