Parking Brake - RED CASTLE Ready2Shop Gebrauchsanweisung

Instructions for use
The READY2SHOP stroller is sold with a seat,
a seat pad, a hood, a bumper bar, a raincover
and a removable basket.
Available on option: a kit for the comfort of
newborns.
1. UNFOLDING THE STROLLER
-
Open the blocking hook (1) on the side
and raise the handlebar until the stroller is
completely unfolded (2 and 3).
WARNING
: Make sure the chassis is firmly
locked in place (click heard).

2. PARKING BRAKE

It blocks the rear wheels.
-
To block the wheels press your foot on the
brake bar (4a).
-
To unblock, raise the brake bar with your foot
(4b).
WARNING
: It may be dangerous to leave
your child alone and unattended, even if the
brake is applied.
WARNING
: Check that the wheels are
properly blocked.
3. USING THE STROLLER
INSTALLING / REMOVING THE SEAT
-
The seat can be positioned to be front or rear
facing. Refer to the table for the configurations
possible (table page 5).
-
To position the seat in place, line up the sides
of the seat with the sockets on the chassis and
set the seat in place (5 and 6).
WARNING:
Make sure that the seats are
firmly engaged (click heard).
-
To remove the seat, raise it up by pressing on
buttons either side of the chassis (7 and 8).
INSTALLING THE SEAT PAD
-
Undo the harness buckles, then slip the
buckles through the slits in the seat pad at the
required height (9). Fasten the harness.
REMOVABLE BUMPER BAR
-
Fit the bumper bar on the side supports
designed for them until click heard (10).
-
To remove it, press on the knobs at either sides
and pull towards you (11).
Bumper bar cover:
-
Surround the bumper bar with the cover,
close the zip (12).
WHEELS
-
Enclench the wheels in place, check that they
are well secured (click heard) (13).
-
To remove them, pull the safety latches
outwards (14).
SAFETY HARNESS
The READY2SHOP stroller has a 5 point harness.
-
Place your child in the stroller and attach the
waist and shoulder straps to the crotch strap
(click heard) (15).
-
To undo the harness (16).
-
To adjust the harness to fit your child, slide the
harness adjusters A, B and C to lengthen or
shorten the straps (17).
-
The harness shoulder straps are height
adjustable. To change the height, remove the
shoulder guards on the straps, open the cover
at the back of the seat and place the straps at
the required height by slotting them through
the board at equal height (18). To do this, tilt
the buckle.
WARNING
: ALWAYS use the crotch strap
in combination with the waist belt when
attaching the harness.
WARNING
: Use a harness as soon as the
child can sit up alone unaided.
4. ADJUSTMENTS
HANDLEBAR
It is height adjustable.
-
Press simultaneously on the light grey buttons
at the side (19) to raise or lower it.
GB
28