Changing The Tool - Bosch GOP 12V-28 Professional Originalbetriebsanleitung

OBJ_BUCH-2853-001.book Page 17 Monday, January 16, 2017 1:56 PM
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
Flashing light 3 x green
When no LED lights up after switching on, then the battery is
defective and must be replaced.

Changing the Tool

 Before any work on the machine itself (e. g. mainte-
nance, tool change, etc.) as well as during transport
and storage, remove the battery from the power tool.
There is danger of injury when unintentionally actuating
the On/Off switch.
 Wear protective gloves when changing application
tools/accessories. Contact with the application tool/
accessory can lead to injuries.
The following table shows examples for application tools. Further application tools can be found in the extensive Bosch acces-
sories program.
Accessory
BIM segment saw
blade
Base plate for
sanding, series
Delta 93 mm
Profile sander
BIM plunge cut
saw blade, wood
and metal
HCS plunge cut
saw blade, wood
Bi-metal plunge
cut saw blade,
hardwood
Bosch Power Tools
Selecting the Application Tool/Accessory
Capacity
Accessory
≥2/3
≥1/3
<1/3
Reserve
Empty
Material Application
Wooden materials, Separating and plunge cuts; also for sawing close to edges,
Plastic, in corners and hard to reach areas;
Non-ferrous metals example: shortening already installed bottom rails or door
hinges, plunge cuts for adjusting floor panels
Depends on sanding sheet Sanding surfaces close to edges, in corners or hard to
reach areas;
depending on the sanding sheet for, e.g., sanding wood,
paint, varnish, stone
Fleeces for cleaning and for texturing wood, removing rust
from metal and for keying varnishes, polishing felt for pre-
polishing
Wood, Convenient, efficient sanding of profiles up to a diameter of
Pipes/Profile, 55 mm;
Paint, Red sanding sheets for sanding wood, pipes/profiles,
Varnishes, varnishes, fillers and metal
Filler,
Metal
Softwood, Smaller separating and plunge cuts;
Soft plastics, example: cutting an opening for sockets, flush cutting a
Plasterboard, copper pipe, plunge cuts in plasterboard
Thin-walled aluminium
Filigree adjustment work in wood;
and non-ferrous metal
example: sawing openings for locks and fittings
profiles,
Thin sheet metals,
Non-hardened nails and
screws
Wooden materials, Separating and deep plunge cuts; also for sawing close to
Soft plastics edges, in corners and hard to reach areas;
example: narrow plunge cut in solid wood for installing a
ventilation grid
Hardwood, Plunge cuts in laminated panels or hardwood;
Laminated panels example: installing skylights
English | 17
GOP 12V-28
1 609 92A 2LW | (16.1.17)