HP DesignJet T1200 Serie Einführende Informationen Seite 4

Message or code
[Color] printhead #[n] error: not
present
[Color] printhead #[n] error:
please remove
[Color] printhead #[n] error:
replace
[Color] printhead #[n] error:
reseat
[Color] printhead #[n] out of
warranty
[Color] printhead #[n] warranty
warning
IO error
IO warning
Paper advance calibration
pending
Paper too small to print paper
advance calibration
Paper too small to scan paper
advance calibration
PDL Error: Ink system not ready
PDL Error: Job clipped
PDL Error: memory full
PDL Error: out of paper
PDL Error: parsing error
PDL Error: print mode error
PDL Error: printing error
PDL Error: virtual memory full
Printhead alignment error:
paper too small
Replace [color] cartridge
Reseat [color] cartridge
Update: failed. Invalid file
01.0, 01.1, 01.2
21, 21.1, 22.0, 22.1, 22.2,
22.3, 24
3 Introductory Information
Recommendation
Insert the correct printhead.
Remove the incorrect printhead and insert a new printhead of the correct type
(color and number).
Remove the non-functional printhead and insert a new printhead.
Remove and reinsert the same printhead, or try cleaning the electrical
connections. If necessary, insert a new printhead.
The printhead's warranty has expired, because of the length of time it has
been in operation or because of the volume of ink used.
The printhead's warranty may be invalidated by the use of the wrong kind of
ink.
Restart the printer. If the problem persists, contact HP Support.
Try again; if the problem persists, contact HP Support.
Perform paper advance calibration.
Unload paper and load larger paper.
Unload paper and load larger paper.
Clean the printheads.
The image is too large for the paper or for the printer. Load larger paper if
possible, or reduce the image size.
Restart the printer and try resending the job; if necessary, reduce the
complexity of the job.
Load more paper.
The print job is unintelligible to the printer. Try to recreate and resend it. Check
your cable connections.
The paper type or print quality specified for the job are incorrect. Change the
loaded paper type or the print settings.
Try sending the job again.
Restart the printer and try resending the job; if necessary, reduce the
complexity of the job.
Unload paper and load larger paper.
Replace the cartridge.
Remove and reinsert the same cartridge.
Make sure that you have selected the correct firmware update file. Then try
again to perform the update.
Restart the printer. If the problem persists, contact HP Support.
Restart the printer. If the problem persists, contact HP Support.