Cleaning And Sterilising The Breast Pump - Beurer BY 70 Gebrauchsanweisung

2. Insert the silicone tubes for two-sided pumping into
the 2 pump attachments and the breast pumps
3. For one-sided pumping, insert the silicone tube with-
out adapter into the pump attachment and the breast
pump.
4. Connect the breast pump to the mains cable and in-
sert the mains plug into the socket.
5. If you instead choose to operate the breast pump
using batteries, open the battery compartment cov-
er on the rear side of the motor unit. Insert four AA
batteries (included in delivery). Make sure that the
batteries are inserted the correct way round. See
the graphic in the battery compartment. Next, close
the battery compartment until you can hear and feel
it click into place. A single battery charge with four
new AA batteries will last for approximately 60 min-
utes of operation (at the lowest setting).

6.2 Cleaning and sterilising the breast pump

WARNING
Clean and sterilise the separate parts of the breast pump that come into direct contact with the
breast milk (except for the motor unit and silicone tube) individually before first use and any further
use. Never sterilise the motor unit.
To sterilise the breast pump correctly, proceed as follows:
1. Unscrew the pump attachment from the bottle.
2. Remove the silicone tube from the pump attachment and the motor unit.
3. Remove the silicone membrane and silicone valve from the pump attachment.
4. Sterilise the bottles and pump attachments (with silicone membrane and silicone valve) for five minutes
in boiling water or using a steam steriliser. Do not use the breast pump until all individual parts are com-
pletely dry. Do not use any antibacterial cleaning products, since these may damage the plastic on the
breast pump.
23