Cleaning And Care - Gastros InductWarm 130 Betriebsanleitung

Cleaning and Care

Glass ceramic
We recommend using dishes with flat bases to avoid any potential surface damage such as scratches. However, if si-
gns of use like this do appear on your warming surface, it will not impair the warming process in any way.
Cleaning tips:
• First, use a scraper to remove all large pieces of dirt and food leftovers from the warming surface.
• Then squeeze a few drops of a suitable cleaning product on to the cold surface and rub it in with kitchen paper or
a clean cloth.
• Then wipe down the warming surface with water and rub it dry with a clean cloth.
• Clean your warming surface regularly, preferably after each use.
Important: If any plastic objects, aluminium foil, sugar or food containing sugar accidentally melt on to the
hot warming surface, wipe them off the hot warming zone immediately with a cleaning scraper to prevent
surface damage. Never use scouring sponges or scouring products. Chemically aggressive cleaners such as
oven spray and stain remover are also unsuitable.
Daily Cleaning
For cleaning: Switch off the InductWarm
to hand temperature before starting to clean.
Please note: Do not use steel wool or sharp objects. Your induction warming appliance is not splash-water resistant.
Therefore, do not use running water or steam to clean it. To remove dirt and deposits on side walls, you can use
standard pH-neutral cleaning products based on non-ionic and anionic tensides and mild organic solvents such as
alcohol and glycols. Finally, remove all cleaning product residue, wipe down the cleaned surfaces with water, and rub
dry with a dry cloth.
In addition to daily cleaning, the air filter on the device bottom (kindly see picture above) must be cleaned when
dirty. Firstly to ensure a sufficient supply of cooling air and secondly to prevent the filters' effectiveness for grease
and other vapours from being impaired. To do this remove the filter from below the air inlet and exchange it with an
optional replacement filter of Gastros (article no. 6 13 610 00). Refit the filter correctly before using your InductWarm
130 appliance again.
Important: A dirty filter may cause overheating, resulting in a drop in performance and damage to the
InductWarm
and damage to the InductWarm
14
130 Tabletop appliance. Wait until the InductWarm
®
130 appliance! A missing filter may allow dirt to accumulate, resulting in a drop in performance
®
130 appliance!
®
130 appliance has cooled
®
®