Setting The Code - Pepeo Turno Montage- Und Bedienungsanleitung

READ THE INSTRUCTIONS
1 LED Transmit
2 FAN Speed Control Button:
LOWEST
I
LOW
II
MED
III
MED
IV
3 Reverse Function Button
4 Lighting Control Button
5 Code switch
6 Setting button
7 Battery

SETTING THE CODE

If you have two or more ceiling fans in one room, please remember to use different code combinations to
prevent interference. Remember to turn off the power supply of other fans, otherwise it will cause a
transmitter to control both fans in the same time.
Step 1. Switch off circuit breaker.
Step 2. Install 12 volt battery. Step 3. Use a small screwdriver or a ball point pen to slide up and down in
order to set your choice of code combinations. (The unit has 16 different code combinations.)
Step 4. Turn the ceiling fan power on within 60 seconds and press the SET button near the ceiling fan
(within 5meter) for 5 seconds to make the CODE re-learn function. Please wait for 5 minutes and the
receiver will automate to detect the current power consumption. Fan will turn in clockwise and counter-
clockwise. After completion of learning operation the fan will stop.
Operating Instruction of Remote Control
HIGH
V
HIGHEST
VI
FAN OFF BUTTON
Model: Turno