Using Your Cam And Smart Card; Physical Installation; Connecting To Audio & Video Devices - Maximum S-6002 CI HD Benutzerhandbuch

Using Your CAM and Smart Card

Your service provider may encrypt some of his satellite channels. To view these channels, you have to
purchase an appropriate CAM (Conditional Access Module) along with an access package from your
service provider. You also need to make sure that the smart card has been inserted into the slot on the
front of the decoder.
The CAM provides the decoding access to certain Conditional Access. The Smart Card is used to identify
your decoder to the service provider and authorize you to de-scramble satellite signals.
Your S-6002 CI HD Satellite Receiver includes two CI slots. You may insert the CAM into either of them.
Before inserting a smart card into the CAM, please note the following precautions:
•
Do not bend or twist the card.
•
Keep the card out of direct exposure to sunlight or any other heat sources.
•
Do not remove/insert the card repeatedly into the slot.
•
Clean the card only with soft dry tissue. Do not use liquids or detergents to clean it.
•
Record the card number for future reference in case the card is damaged or lost.
•
If the card is damaged or lost, contact your service provider for a replacement.

Physical Installation

Please always remember to disconnect the satellite decoder from the power source prior to connecting or
disconnecting the cable to the LNB (on the satellite dish).
When the decoder is connected to the satellite dish, it may supply voltage to the LNB. You should therefore
disconnect the receiver from the power source before attaching the LNB or any other equipment.
Connecting To Audio & Video Devices
There are many ways to connect the satellite receiver to your home entertainment system, depending
on the equipment and connection types you have.
However, for better video/audio quality, use HDMI, YP
higher video and audio quality
SUBT: For DVB Subtitle.
P and SPDIF/ Coaxial connections to obtain
B R
- 9 -