Safety First - Maximum S-6002 CI HD Benutzerhandbuch

Safety First

Please review the following safety precautions. If this is the first time to use a satellite receiver, then read
this manual before installing or using this receiver. If the receiver is not functioning properly, please contact
your local distributor or system installer.
The lightening symbol in a triangle is used to alert you to the presence of dangerous voltages
inside the receiver that may be sufficient to constitute a risk of electric shock to anyone opening
the case. It is also used to indicate improper installation or handling of the receiver that could
damage the electrical system in the receiver or in other equipment attached to the receiver.
The exclamation point in a triangle is used to alert you to important operating and maintenance
instructions. Failure to follow these instructions could result in injury to you or damage to the
receiver.
Be careful with electricity:
Power outlet: To prevent electric shock make sure the electrical plug used on the receiver's power
cord matches the
to a power source that operates at 100~240 Volts AC, 50/60 Hz.
Power plug: If a three-prong power plug is provided with the receiver, make sure it is used with a
properly grounded three-wire power socket.
Power cord: Make sure the power cord is routed so that it will not be stepped on or pinched by heavy
items.
Power overloading: Avoid overloading electrical outlets or extension cords, which otherwise could
result in electric shock or fire.
Lightening: For protection from lightening, or when the receiver is left unattended for a long period,
disconnect it from the power source.
Protect other equipment: Unplug the receiver before connecting any other equipment, especially the
dish antenna connect all equipment to the receiver before plugging any power cords to the power
source.
Also follow these precautions:
Ventilation: Do not block the ventilation slots on the receiver, or place any heavy object on top of it.
Blocking the airflow could damage the receiver. Arrange components so that air can flow freely around
the receiver. Ensure that there is adequate ventilation if the receiver is placed in a stand. Put the
receiver in a properly ventilated area, away from direct sunlight or any source of heat.
Overheating: Avoid stacking the receiver on top of a hot component such as a power amplifier.
WARNING!
RISK OF ELECTRICAL
SHOCK
DO NOT OPEN
WARNING:
TO REDUCE THE RISK OF ELECTRICAL
SHOCK
DO NOT REMOVE THE COVER
NO USER-SERVICEABLE PARTS ARE INSIDE
REFER SERVICING TO QUALIFIED
PERSONNEL
electrical outlet used to supply power to the receiver. Connect the power cord only
- 2 -