Herunterladen Inhalt Inhalt Diese Seite drucken

Nordpeis Orion Montageanleitung Seite 8

Vorschau ausblenden Andere Handbücher für Orion:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

IMPORTANT SAFETY PRECAUTIONS!
1. Please follow the installation manual when
connecting your stove / fireplace to the chimney /
flue pipe. If connected differently from instruction
please, consider the heat radiation from the flue
pipe to the surrounding materials.
2. Before use, please carefully read the user manual
and follow the instructions.
3. Integrated or defined convection openings may
never be reduced or partially obstructed. This may
lead to overheating, which again can cause house
fire or serious damage to the product.
4. Use only designated fire starters. Never use
gasoline, diesel or other liquids to start the fire.
This may cause explosions!
5. Never use other fuel than natural dry chopped
wood. Briquettes, peat, coke, coal and waste
from construction materials develops far higher
temperatures and emissions than natural wood.
Since your product has been designed for use
with natural wood only, other fuels may damage
the product, chimney and surrounding
constructions.
6. In case of damage to glass or door gasket, all use
of the product must be discontinued until the
damage has been repaired.
Failure to follow these precautions will leave your
warranty void and expose people and property to
danger.
Advise: Even if not required in your area, it is always
wise to have a qualified stove / fireplace fitter do the
installation, or at least the final inspection before use.
INDEX
1. Prior to assembling the stove
Chimney Draught
2. Technical Information
3. Distance to combustible material
4. Assembly
Connection of the flue
Operating control
5. Lighting the fire for the first time
6. Maintenance
Cleaning and inspection
Ashes
Thermotte® Plates
Door and glass
7. Warranty
8. Advice on lighting a fire
Some advice in case of combustion problems
8
1. Prior to assembling the stove
All our products are tested according to the latest
European requirements and also to the Norwegian
SINTEF standard, which includes particle tests.
Several European countries however have individual
rules for installation of inserts, stoves and fireplaces.
The client is entirely responsible for the fulfilling of
these local rules concerning the installation in his
region/country. Nordpeis (Northstar) is not responsible
regarding correct installation. You should check local
regulations concerning: distance from firebox to
combustible/flammable materials, insulation materials/
requirements between stove and back wall, size
of floor plates in front of stove if required, fluepipe
connection between stove and chimney and insulation
requirements if fluepipe goes through inflammable
wall such as a wooden wall.
Chimney Draught
Compared with older models, the clean burning stoves
of today put significantly higher demands on the
chimney. Even the best stove will not work properly
if the chimney does not have the right dimensions or
is not in good working order. The draught is mainly
controlled by gas temperature, outside temperature,
air supply as well as the height and inner diameter
of the chimney. The diameter of the chimney should
never be less than that of the flue/chimney collar. At
nominal effect there should be a negative pressure of
14 to 25 Pascal.
The draught increases when:
The chimney becomes warmer than the outside air
The active length of the chimney is increased (over
the hearth)
Good air supply to the combustion
It can be difficult to obtain the right draught conditions
in case the chimney is too large relative to the
8
fireplace, as the chimney does not heat up well
8
enough. If possible, insert a smaller chimney
pipe. Draught that is too strong can also be
9
controlled with a damper. If necessary, contact a
9
chimney sweeper.
9
For your own safety, comply with the assembly
9
instructions. All safety distances are minimum
9
distances. Installation of the insert must comply
9
with the rules and regulations of the country where
installed. Nordpeis AS is not responsible for wrongly
10
assembled inserts.
10
10
The illustration indicates the approximate center height
10
of the hole for the flue. Distortions in floors and walls
10
may influence the height. Place the stove for accurate
11
position and height of the flue/chimney connection.
11
We accept no liability for typographical errors and
changes.
12
GB

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Sn-00000-000

Inhaltsverzeichnis