Eneo VMC-19LCD-HPC1 Montage- Und Betriebsanleitung Seite 14

3. Operating Instruction
FRONT controls
1. Menu / Exit
This button is used to bring up or disappear the
controls menu. Exits from the OSD system and the
selected function.
2. (Down) / (Brightness)
Moves down the menu lists in the OSD.
Selected brightness and decreases the value of
brightness.
REAR connection
3. (UP) / Source
Moves up the menu lists in the OSD.
While in the normal active (Not MENU DISPLAY)
mode, this button is used to bring up Source select
Menu (CVBS, S-VIDEO, RGB)
4. (Select) /
This button to choose on the menu then
pushes the button: While in the CVBS, S-Video mode,
press this button to FREEZE (
display. Press again to exit the FREEZE image.
While in the RGB mode, press this button to AUTO
adjust the H/V POS, H/V SIZE, and phase.
5. LED
A green indicator lights when the power is ON and
input signal (the indicator blink when the power is
ON and Input NO signal). A red indicator lights when
the power is OFF.
6. Power On/Off
When power is supplied, the monitor will come ON.
This button then turns the monitor ON and OFF.
1. DC jack
Place the plug from the supplied table-top power
supply into the VDC connector. Input at the
monitor is VDC from the TT universal AC supply
(00-40VAC, see specifications table for AC/DC
details).
2. RGB input
Connect to the video output port on your PC or DVR.
3. S-Video input
Used to connect a S-Video signal from a camera
or DVR
4. CVBS input
Used to connect a BNC Video signal from a camera
or DVR
4
(Freeze) / AUTO
) the picture for