Glo ™ Glonass And Gps Sensor Instructions; Installing The Battery; Replacement Battery; Charging The Battery - Garmin GLO Anweisungen

GLO GLONASS and
™
GPS Sensor Instructions

Installing the Battery

WArNING

This product contains a lithium-ion battery�
See page 5 for important battery safety
information�
1
With your thumbnail, slide the battery
cover release tab
➋
2
Remove the battery cover
3
Locate the metal contacts on the end
of the lithium-ion battery�
4
Insert the battery
contacts on the battery align with
the metal contacts inside the battery
compartment�
5
Press the battery down into place�
2
�
➊
➊
➌
�
➋
so the metal
➌
6
Insert the battery cover into the
notches and press down�
The release tab locks the cover in
place�

replacement Battery

You can purchase a replacement battery
(010-10840-00) at http://buy�garmin�com�

Charging the Battery

You can use the sensor while you are
charging it�
1
Plug the small end of the power cable
into the mini-USB connector on the
end of the sensor�
2
Plug the other end of the power cable
into an appropriate source of power for
the cable type�
It takes about three hours to charge the
battery� A fully charged battery lasts about
12 hours�
NOte: If the battery has not been charged
for a long period of time, remove the
battery, connect the cable to the device
and a power source, and then replace the
battery� The battery will charge as usual�