Warning Signal - AEG Electrolux SKS88840F0 Benutzerinformation

34
What to do if...
Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on the
ground.
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.
The temperature in the re-
frigerator is too high.
The temperature in the
freezer is too high.
There is too much frost.

Warning signal

The warning signals of the control and signalling system of the appliance are displayed on
the Visual Display.
The system will give out a signal if:
Possible cause
The product temperature is too
high.
The room temperature is too
high.
During the automatic defrosting
process, frost defrosts on the
rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
The melting water outlet does
not flow in the evaporative tray
above the compressor.
The temperature regulator is not
set correctly.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not
set correctly.
Solution
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.