Operating Determinations; Installation; Operation; Cleaning And Maintenance - Eurolite Led Ribbon Horizontal Bedienungsanleitung

• no longer functions
• is visibly damaged
• has been stored long-term under adverse conditions, or
• has been exposed to stress during transport.
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a lighting chain for creating decorative effects. This product is allowed to be operated with an
direct current of 24 V.
The device must only be operated with an appropriate transformer suitable for the power consumption.
This device is waterproof (IP X8) and therefore qualified for indoor and outdoor use. In order to maintain this
protection grade after opening the housing, any rubber sealings must be examined for damages and always
be correctly installed.
For outdoor use, the installer must always make sure to connect a rubber cable H05RN-F or HO5RR-F. For
installations in the ground, an underground power cable NYY must be used!
All valid instructions concerning the installation of cables outdoors or in the ground must be adhered!
The ambient temperature must always be between -25° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The maximum relative humidity is 100 % with an ambient temperature of 25° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.

INSTALLATION

Unpack the LED Ribbons and connect up to the desired length. The LED Ribbons can be connected via the
plug sockets on the link connectors.
Only cut the LED Ribbons where marked. The tube can be cut after every 6 lamps.
Make sure that you only connect 24 V-versions.
The maximum length must not exceed 20 m.
The tube is water-proof (IP 68). Nevertheless, you have to insulate the link connectors, the power-
connector and the end cap with some silicone or with the heat-shrink tube for outdoor-use.
In order to design the desired patterns, draw the form onto the surface and attach the mounting-clips.
The last LED Ribbon has to be terminated with an end cap. Please make sure that you glue the end
cap on the tube.
Connection with the mains:
Connect the power-connector to the appropriate transformer. Connect the transformer to the mains. Make
sure that the outlet is in a dry area.
The LED Ribbon must never be covered with any object.

OPERATION

After you connected the ribbon to the mains, the LEDs start burning.

CLEANING AND MAINTENANCE

DANGER TO LIFE!

Disconnect from mains before starting maintenance operation!
8/9 00042193.DOC Version 1.0