Rittal DK 7030.100 Kurzbedienungsanleitung Seite 8

Installation and operation, Service
Display of the status change on the multi-LED of the CAN bus sensor.
– Continuous blue flashing: Communication over the CAN bus.
EN
– Green flashing: When the measured value changes or, at the latest, every 5 seconds.
If the installation is not successful: see section 1.1.
Note:
Connection cables in various lengths can be obtained from Rittal.
5.3 Settings
Visit the CMC III PU web site to set or view the parameters of the connected CMC II sensors. They differ
in detail depending on which sensor is actually connected.
Analogue sensor:
– Value: Currently measured value
– SetPtHighAlarm: Upper alarm limit value
– SetPtHighWarning: Upper warning limit value
– SetPtLowWarning: Lower warning limit value
– SetPtLowAlarm: Lower alarm limit value
– Hysteresis: Status message delay [%]
– Status: Current status of the associated CMC II sensor taking account of the hysteresis
Digital input or digital output:
– Value: Current status of the input of the output (0 or 1)
– Delay: Status message delay [s]
– Status: Current status of the associated input or output taking account of the delay value
To determine whether any software updates are required: see www.rittal.com or contact Rittal Service
(see section 6).
6 Service
For technical questions, please contact:
Tel.: +49(0)2772 505-9052
E-mail: info@rittal.de
Homepage: www.rittal.com
For complaints or service requests, please contact:
Tel.: +49(0)2772 505-1855
E-mail: service@rittal.de
8 Rittal CMC III CAN-Bus Sensor