Mantis 8580 Gebrauchsanweisung Seite 18

8. Technical Specifications
battery-operated pole pruner 8580 (aas 2420)
Rated Voltage
No-load Speed
Guide Bar
Cutting length
Variable height adjustment
Working height
Oil
Weight with bar+chain
Chain type
Guide Bar type
Sound Pressure Level (
EN ISO 11680-1)
Acoustic capacity level L
WA
Vibration (
EN ISO 11680-1)
Mains battery charger
Mains voltage
Charging voltage / Charging current
Period of charging
Technical changes are reserved.
Noise emission information in accordance with the German Product Safety Act (ProdSG) and the EC Machine Direc-
tive: the noise pressure level at the place of work can exceed 80 dB(A). In such cases the operator will require noise
protection (e.g. wearing of ear protectors).
Wear hearing protection. The influence of noise can cause hearing loss.
attention!
The vibration value will change on the basis of the area of application of the electric tool and may lie above the
specified value in exceptional situations.
Keep the development of noise and vibration to a minimum!
• Only use properly functioning machines.
• Maintain and clean the machine regularly.
• Adapt your working method to the machine.
• Do not overstress the machine.
• If necessary, have the machine inspected.
• Switch the machine off when it is not in use.
• Wear work gloves.
attention: noise protection! Please observe the local regulations when operating your device.
Warning!
The prolonged utilisation of a tool will subject the user to vibration and shocks that could lead to Raynaud's syndrome
or Carpal tunnel syndrome.
This condition reduces the ability of the hand to sense and regulate temperature, causes numbness and a sensation
of heat and can lead to damage to the nervous system and the circulatory system and to necrosis.
Not all factors that lead to Raynaud's syndrome are known but cold water, smoking and illnesses that impact the blood
vessels and the circulatory system as well as severe or long-lasting exposure to vibrations are known to be factors in
the development of Raynaud's syndrome. Observe the following in order to reduce the risk of Raynaud's syndrome
and Carpal tunnel syndrome:
• Wear gloves and keep your hands warm.
• Make sure the device is well maintained. A tool with loose components or with damaged or worn-out dampers will
have a disposition towards increased vibrations.
• Always hold the handle firmly but do not clutch it constantly with excessive force. Take breaks often.
All of the above precautions cannot exclude the risk of Raynaud's syndrome or Carpal tunnel syndrome. Therefore,
with long-term or regular use it is advisable to keep a close watch on the condition of your hands and fingers. Seek
medical attention immediately in the event of any of the above symptoms appearing.
18
(
EN ISO 11680-1)
Cordless Pole Pruner Operator's Manual
24 V DC / 1,9 Ah / 45,6 Wh
-1
1800 min
200 mm
ca. 17,5 cm
from 1.85 m to 3.15 m
up to 4.5 m
60 ml
3.8 kg
91PJ033X
080SDEA041
76,60 dB(A)
K = 2.5 dB
92 dB(A)
K = 3 dB
2
1.251 m/s 2
K = 1.5 m/s
230 V~ / 50 Hz
25.9 V DC / 500 mA
approx 3-5 hour