Controls - Electrolux WEGL1030CN Gebrauchsanleitung

6. CONTROLS

The hood can be switched on pushing directly onto the requested speed
without firstly having to select 0/1 button.
Basic function
Button
Dual Function
Press briefly to turn the lighting system on and off.
Press and hold the button for 2 seconds to activate
the lighting system in "courtesy light" mode. The lights
L
are lit at a reduced power of approximately 5W. This
function can be disabled by pressing the button once
again for 2 seconds or by pressing it briefly to switch
to normal lighting mode.
Turns the motor off from whatever speed it is set to.
T1
Press and hold the button for 3 seconds with all
the loads turned off (Motor and Lights), to turn the
Activated Charcoal Filter alarm on/off.
T2 Turns the motor on at speed one.
When pressed briefly, turns the motor on at speed
two.
Press and hold the button for approximately 2" to turn
the Delay function on and off, that is to say to turn
T3
the appliance off after a 20 minute delay. Suitable to
complete elimination of residual odours. Can be acti-
vated from the OFF position and from speeds 1, 2, 3.
Cannot be activated with Intensive speed On.
T4 Turns the motor on at speed three.
Turns the motor On and Off at Intensive speed for
a timed period of 5 minutes. At the end of the 5
minutes the appliance will automatically return to
T5
the speed that was set before. If the appliance was
turned off at the time of activation, at the end of the 5
minutes the system will return to speed one.
Press and hold for 4 seconds to reset the filter alarm
F indicator, shown by flashing of button T1. This proce-
dure can only be carried out with the motor off.
L T1 T2 T3 T4 T5 F
Indicator lights
Button off Lights off
Button lit Lights on
Button lit Courtesy light on
Button lit Motor active
Motor inactive
Button flashes twice F – Alarm On.
Button flashes once F – Alarm Off.
Button on
Button on Speed two on
Buttons flash-
ing (T1+T2 or Delay functionActive
T3 or T4)
Button on
Button on
Signals the Metal Grease Filter
saturation alarm, indicating that it
is necessary to wash the filters.
Button on
The alarm is triggered after the
Hood has been in operation for
100 working hours.
When this is activated, it signals
the Activated Charcoal Filter
saturation alarm, indicating that
the filter must be changed; the
Button
Metal Grease Filters must also be
flashing
washed. The Activated Charcoal
Filter saturation alarm comes
into operation after the Hood has
been working for 200 hours.
ENGLISH 11