Daily Use; Automatic Switch-Off; The Heat Setting; Automatic Heat Up - AEG HK764400XB Benutzerinformation

www.aeg.com
8

4. DAILY USE

4.1 Activation and
deactivation
Touch
activate the appliance.
4.2 Automatic Switch Off
The function deactivates the appliance
automatically if:
• All cooking zones are deactivated (
).
• You do not set the heat setting after
you activate the appliance.
• You spill something or put something
on the control panel for more than 10
seconds, (a pan, a cloth, etc.). An
acoustic signal sounds some time and
the appliance deactivates. Remove the
object or clean the control panel.
• The appliance becomes too hot (e.g.
when, a saucepan boils dry). Before
you use the appliance again, wait for
the cooking zone to cool down.
• You use incorrect cookware. The sym-
bol
zone deactivates automatically after 2
minutes.
• You do not deactivate a cooking zone
or change the heat setting. After some
time
deactivates. See below.
• The relation between heat setting and
times of the Automatic Switch Off
function:
•
,
•
-
•
-
•

4.3 The heat setting

Touch the control bar at the heat set-
ting. Move your finger along the control
bar to change the setting. Do not re-
lease before you have a correct heat set-
ting. The display shows the heat setting.
for 1 second to activate or de-
comes on and the cooking
comes on and the appliance
- — 6 hours
— 5 hours
— 4 hours
- — 1.5 hours

4.4 Automatic Heat Up

You can get a necessary heat setting in a
shorter time if you activate the Automat-
ic Heat Up function. This function sets
the highest heat setting for some time
(see the diagram), and then decreases to
the necessary heat setting.
To start the Automatic Heat Up function
for a cooking zone:
1.
Touch ( comes on in the dis-
play).
2. Immediately touch the necessary
heat setting. After 3 seconds
comes on in the display.
To stop the function change the heat
setting.
12
11
10
9
8
7
6
5
4
3
2
1
0
1 2 3 4 5 6 7 8 9 10 11 12 13 14

4.5 Power function

The Power function makes more power
available to the induction cooking zones.
The Power function can be activated for
a limited period of time ( see Technical
Information chapter). After that, the in-
duction cooking zone automatically sets