AEG DI 8616 Benutzerinformation Seite 84

• For extractor versions (13A), connect the other end of the exhaust
pipe to the flue.
For filter versions (13F), fit deflector F to the support and secure it
to the bracket supplied using 4 screws.
The three parts should be fixed with 2 screws, the deflector
extension is adjustable and should correspond to the width of the
chimney flue support, to which it is then fixed.
Connect the exhaust pipe to the connection ring located on the
deflector.
• Fit the nuts with fixing hooks (14) supplied inside the top and bottom
sections of the flues at the rectangular slots. A total of 14 nuts must
be fitted.
• Join the two top sections of the flue to cover the support (15) so that
one of the slots on the sections is situated on the same side of the
control panel and the other on the opposite side. Screw the two
sections together with 6 screws (3 each side- see the plan diagram
for joining the two sections).
• Fix the top flue assembly to the support, near the ceiling, with two
screws+2 nuts (16 - one each side).
Optionally, the position of the flue elements can be changed.
When using the hood in the recirculation mode the chimney must
be fixed at the top, with the air outlet grill at the side.
• Carry out electrical connection of control panel and bulbs (17).
84