Charcoal Filter - AEG DD 9863 Benutzerinformation

Charcoal filter

• The charcoal filter should only be used if you want to use the hood
in recirculation mode.
• Cleaning/replacing the carbon filter
Unlike other carbon filters, the LONGLIFE carbon filter can be
cleaned and reactivated. At normal use the filter should be cleaned
every second month (when using the hood 2,5 hours per day, in
avarage). The best way to clean the filter is in the dishwasher. Use
normal detergent and choose the highest temperature (65º C).
Wash the filter separately so that no food parts gets stuck on the
filter and later causes bad odours. To reactivate the carbon, the filter
should be dried in an oven for 10 minutes with a temperature of
maximum 100º C.
After approximately three years of use, the carbon filter should be
replaced with a new one, as the odour reduction capacity will be
reduced.
• Fitting
Remove the perimeter air suction panels.
Remove the inner crosspiece.
Remove the grease filters.
Position the carbon filter inside the hood to cover the protection grill
of the motor. Fix the filter with 2 lateral knobs. Fig. 5
Reattach the grease filters, the inner crosspiece and the perimeter
air suction panels.
• To remove proceed in the reverse order.
• Always specify the hood model code number and serial number
when ordering replacement filters. This information is shown on the
rating plate located on the inside of the unit.
• The charcoal filter can be ordered from your local Service Force
Centre.
Fig. 5
73