Odours; Light (Led); Tips For Saving Energy - Siemens KI42FP60 Gebrauchsanleitung

en
Taking out the humidity filter
Fig. !/18
The humidity filter over the humidity
container can be taken out for cleaning.
To do this, first take out the humidity
container and pull out the humidity filter.
Lift off the filter cover, Fig. *, and take
out the filter. Clean in lukewarm water,
leave to dry and re-assemble.
Remove telescopic rails
Fig. ,
1. Pull out the telescopic rail.
2. Push lock in the direction of the arrow.
3. Detach telescopic rail from the rear
pin.
4. Push telescopic rail together, push
backwards above the rear pin
and disengage.
Installing telescopic rails
1. Place the extended telescopic
rail on the front pin.
2. Pull the telescopic rail forwards
slightly until it engages.
3. Place telescopic rail on the rear pin.
4. Push lock backwards.

Odours

If you experience unpleasant odours:
1. Switch off the appliance with the
On/Off button. Fig. !/6.
2. Take all food out of the appliance.
3. Clean interior (see chapter "Cleaning
the appliance").
4. Clean all packages.
5. Seal strong smelling food in order
to avoid odours from forming.
6. Switch the appliance on again.
7. Store food in the appliance.
32
8. Check whether the formation
of odours is still occuring after
24 hours.
9. Change odour filter, Fig. +.
The odour filter is situated behind
the upper "cool-fresh" container.
Replacement filters are available from
your customer service.

Light (LED)

Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.

Tips for saving energy

Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Allow warm food and drinks to cool
■
down before placing in the appliance.
Thaw frozen food in the refrigerator
■
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
Open the appliance as briefly as
■
possible.
To prevent increased power
■
consumption, occasionally clean
the ventilation opening with a paint
brush or vacuum cleaner.
The arrangement of the fittings does
■
not affect the energy rating of the
appliance.