Husqvarna Royal 47RC Betriebsanleitung Seite 8

B
Product Number . . . . . . . . . . . . . .
Model Number . . . . . . . . . . . . . . . .
Serial Number . . . . . . . . . . . . . . . .
Date of Purchase . . . . . . . . . . . . . .
Place of Purchase . . . . . . . . . . . . .
•PLEASE KEEP PROOF OF PURCHASE•
Handle Assembly
1. Your product is
supplied with the
handles folded over
the product. (C1)
2. Loosen handle
adjusters (C2) on
both sides of the
product and lift
handle assembly up.
3. Adjust handle
assembly to the most
comfortable
operating position
(C3) and tighten
handle adjusters
(C2) on both sides of
the product
3. Ensure the power cable is not trapped
between the handles or the handle
adjusters.
English - 3
PRODUCT RATING LABEL
ASSEMBLY INSTRUCTIONS
C1
C2
Handle Adjuster
C3
Your product is uniquely identified by a
silver and black product rating label. To
ensure you have full product information
when obtaining spares or advice from one
of our approved service centres or if you
need to contact our customer service
department you should make a note in the
space provided of the information shown in
Fig B
Fitting the grass collector
1.Raise the safety flap.
2. Place the grass
collector over the
ejection chute.
3. Lower the grass
collector until it is
supported by the
lower handle
sections and place
the safety flap over
the front section of the grass collector.
(D1)
Emptying the grass
collector
1. Lift clamp as shown
in (D2). Release
hook from clamp
2. Swing open grass
collector top and
remove grass. (D2)
Please Note :-
Ensure no gap remains between the safety
flap and the grass collector
Where grass collection is not required you
can use the lawnmower without the grass
collector.
Ensure the safety flap is fully closed
D1
D2