Küppersbusch IKE 156-0 Gebrauchs- Und Montageanleitung Seite 28

GB
4. From the plastic cover (E), which is used to cover
the hinge with the pivot pin, you must take away the
part as indicated in the drawing.
This operation is made easer since there is, in the
internal part of the cover hinge lid a groove that
facilates the removal of this coomponent.
"Remove the part marked with DX, if the pivot pin is
inserted in the right hinge, SX in opposite case."
Apply covers (C-D) on joint cover lugs and into
hinge holes. Snap hinge covers (E) into position.
5. Separate parts Ha, Hb, Hc, Hd as shown in the
figure.
28
6. Place guide (Ha) on the inside part of the
furniture door, up and down as shown in the
figure and mark the position of external holes.
After having drilled holes, fix the guide with the
screws supplied.
7. Fix cover (Hc) on guide (Ha) until it clips into
place.
8. Open the appliance door and the furniture door
at 90°. Insert the small square (Hb) into guide
(Ha). Put together the appliance door and the
furniture door and mark the holes as indicated in
the figure.