One 4 Channel Amplifier In Stereo Mode (Front-/Rear Speakers) With; One 2 Channel Amplifier In Mono/Subwoofer Mode - ESX SX-260 Bedienungsanleitung

One 4 Channel Amplifier in Stereo Mode (Front-/Rear- Speakers) with
One 2 Channel Amplifier in Mono/Subwoofer Mode (Bass Amplifier)
Control settings of the 4 Channel Amplifier:
X-OVER SELECT (CH1/2 & CH3/4)
• If larger than 20 cm speakers are used, the FULL position is recommended.
• For all smaller speakers (Ø8.7cm - Ø16cm) the Highpass-Position (HP) is recommended, which eliminates the lowest
frequencies and protects the speakers from damage. Set the crossover-frequency between 60Hz - 150Hz, depending of the
size of the installed speakers. The Highpass adjustment can be done with the FREQ - ADJUST control.
INPUT LEVEL (CH1/2 & CH3/4)
• Turn the INPUT LEVEL controls on the amplifier to 5V position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the INPUT LEVEL controls clockwise until you hear some distortion.
• Then turn back the INPUT LEVEL controls slightly until you can hear clean sound.
BASS BOOST (CH1/2 & CH3/4)
• Turn the BASS BOOST control into "0dB" - position.
MODE SELECT
• The MODE SELECT - switch from CH1/CH2 must be in "4" - position and the MODE SELECT - switch from the CH3/CH4
must be in "STEREO" - position.
Control settings of the Bass Amplifier (2 Channel Amplifier):
X-OVER SELECT
• In 1 Channel/Mono-Mode select the Lowpass-Position (LP), which eliminates the higher frequencies. The recommended
crossover frequency ranges between 60 - 100Hz, depending on the size and response of the Subwoofer. The Lowpass
adjustment can be done with the FREQ - ADJUST control.
INPUT LEVEL
• see descriptions for 4 Channel Amplifier above
BASS BOOST
• The BASS BOOST - Control increases the bass level at 45 Hz max. +12dB.
Caution! Please use the Bass-Boost carefully. The additional boost may result in clipping or overload.
MODE SELECT
• The MODE SELECT - switch must be in "MONO" - position
30
4 Channel Amplifier - Applications
SX-475/SX-4100
Interconnect cable checklist:
•Connect the INPUT of the 4 Channel Amplifier to the head unit line outputs with good quality
RCA to RCA cables.
• Connect the OUTPUT of the 4 Channel Amplifier with the INPUT of the designated Bass
Amplifier (2 Channel Amplifier) with a further RCA cable.
• Connect the Front-/Rear Speakers with the terminal blocks (SPEAKER OUTPUT/ + CH1 -,
+ CH2 -, + Ch3 - and + CH4 -) of the 4 Channel Amplifier.
• Connect the Subwoofer with the terminal block (SPEAKER OUTPUT/ + BRIDGED -) of the
designated Bass Amplifier (2 Channel Amplifier).
•The minimum final speaker impedance must not be below 2 Ohms for the 4 Channel
Amplifier, the total impedance of the Subwoofer(s) must not be below 4 Ohms. Too low
speaker loads result in too high heat dissipation and may cause the amplifier run into
protection.
• If you use more than one speaker (Subwoofer), make sure that both are connected in
phase. Incorrect polarity of the speakers results in total loss of bass response.
Be careful not to connect speaker (-) to the ground or vehicle chassis.
Caution