Herunterladen Inhalt Inhalt Diese Seite drucken

Electrolux ERT 14001 W8 Benutzerinformation Seite 30

Vorschau ausblenden Andere Handbücher für ERT 14001 W8:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

30 electrolux
The thermostatic control interrupts the
operation of compressor at regular
intervals for more or less time - during this
cooling is interrupted - temperature of the
fresh food compartment increases and
defrosting occurs. After defrosting the
thermostatic control restarts operation of
the system.
Melting water flows through defrost water
outlet into the evaporative tray maintained
on the top of compressor and evaporates
due to warmth of it.
Check and clean the outlet of
melting water coming during
defrosting regularly. If it is clogged
the melting water gathered can cause
earlier failure as it can go to the
insulating of the appliance.
Clean the melting water outlet with the
supplied pipe scraper that can be seen in
the figure. The pipe scraper has to be
stored in the outlet.
Occasionally check defrost water outlet
not to be clogged up.
The most typical case of clogging up in
the defrost water outlet when you put
food wrapped in some paper into the
appliance and this paper contacts back
plate of fresh food compartment and
freezes to it. If you remove the food right
at this moment the paper will tear and it
can cause clogging up in the outlet by
getting into it. So you are asked to be
careful - because of the above - when
placing foods wrapped in paper into the
appliance.
GB
In case of increased demand e.g.
during heatwaves, the refrigerator
temporarily
happens
constantly. During this the automatic
defrosting is ineffective.
Remaining small ice and frost stains on
back plate of the fresh food compartment
after defrosting period is not abnormal.
The frozen food compartment can not be
equipped with automatic defrosting set
since the deep-frozen and frozen foods
do not endure melting temperature.
So the enclosed plastic scraper is for
scraping off and removing frost and ice
coating which possibly occurs in the
frozen food compartment and on the
sealing of the door.
The tray in figure is not a piece of
accessories to the appliance!
When ice coating is so thick that it can
not be removed with the plastic scraper,
the frozen food compartment has to be
defrosted (generally 2-3 times a year).
Take the foods out of the frozen and fresh
food compartment, wrap them into some
layers of paper or cloth. Put them to a
possible cool place while defrosting.
Break the circuit of the appliance and
leave the doors of frozen and fresh food
compartment open.
Continuously blot off the defrosting water
by a soft cloth or sponge.
After defrosting wipe the surfaces, apply
voltage to the appliance and put the
foods back to their places.
GB
to
operate

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis