Renlig FWM5 Handbuch Seite 21

ENGLISH
Problem Possible cause
The inlet hose is squashed or kinked
(The red indicator light of button 5
blinks).
The filter in the inlet hose or the inlet
valve filter are blocked (The red in-
dicator light of button 5 blinks).
The door is not properly closed (The
red indicator light of button 5
blinks).
The drain hose is squashed or
kinked (The red indicator light of
button 5 blinks).
The drain filter is clogged (The red
The appliance
indicator light of button 5 blinks).
does not empty:
An option or a programme that
ends with the water still in the tub or
a that eliminates all the spinning
phases has been selected.
The electronic unbalance detection
device has cut in because the laun-
dry is not evenly distributed in the
drum. The laundry is redistributed
The appliance
by reverse rotation of the drum. This
spinning phase
may happen several times before
starts late or
the unbalance disappears and nor-
does not start:
mal spinning can resume. If, after 10
minutes, the laundry is still not even-
ly distributed in the drum, the appli-
ance will not spin.
Too much detergent or unsuitable
detergent (creates too much foam)
has been used.
Check whether there are any leaks
from one of the inlet hose fittings. It
There is water
is not always easy to see this as the
on the floor:
water runs down the hose; check to
see if it is damp.
The drain or inlet hose is damaged.
The door will
The programme is still running.
not open:
Solution
Check the inlet hose connection.
Clean the water inlet filters. (See
"Cleaning the water inlet filters" for
more details).
Close the door firmly.
Check the drain hose connection.
Clean the drain filter.
Select the draining or spinning pro-
gramme.
Redistribute the load manually or
load more laundry and select the
spin programme.
Reduce the detergent quantity or
use another one.
Check the water inlet hose connec-
tion.
Replace it with a new one (check
with the After Sales Service the right
spare part number).
Wait the end of washing cycle.
21