Care And Maintenance; Troubleshooting Guide - Whirlpool WGKN 1450 A++ Gebrauchsanweisung

CARE AND MAINTENANCE

Before any cleaning or maintenance operation, unplug
the appliance from the mains or disconnect the
electrical power supply.
For electronic models, first press the on/off
button and then unplug the the appliance.
Periodically clean the condenser at the rear of the appliance
with a vacuum cleaner or brush.
Periodically clean the inside of the compartment with a
sponge dampened in warm water and/or neutral detergent.
Rinse and dry with a soft cloth. Do not use abrasive products
Long vacation
Empty the freezer.
Disconnect the freezer from the mains power supply.
Defrost and clean.
Leave the door open to prevent formation of
unpleasant odours and to eliminate any dampness
Note: for electronic models, first insert the power plug
into the mains socket and then press the on/off button
to switch on the appliance.

TROUBLESHOOTING GUIDE

1. The appliance is not working.
Is there a power failure?
Is the main power switch on?
Has the fuse blown?
Is the thermostat setting correct?
Was the appliance switched on correctly?
2. Excessive frost build-up.
Has the defrost water drain been positioned
correctly?
Is the door shut properly?
3. The yellow, red and green LEDs do not
light up. Perform the checks for point
1, and then:
Contact After Sales Service.
Notes:
The front edge of the appliance may be hot.
This prevents the formation of condensation
and is not a defect.
Gurgling and hissing noises due to
expansion in the refrigerant circuit are
normal.
11