Vigor V 2480 Betriebsanleitung Seite 15

6. Faults
If faults occur, check the following:
• Jack will not raise.
– The drain valve is not sufficiently closed. Close the valve.
– The jack is overloaded.
– Reduce the load or use a jack with a higher load capacity.
• Jack will not raise properly; it cannot reach its maximum height.
– T here is air in the system.
L ower the hydraulic arm, place the jack on its side and remove the oil filler screw to bleed the air out
of the system. Replace the oil filler screw, ensuring that it has been tightly screwed in.
– T he oil pressure is too low.
Refill the oil.
Express or implied warranty
I mproper use of the tool invalidates any express or implied warranty. Improper use of the tool includes:
• Changing, modifying or repairing the tool with parts that are not ViGOR equipment.
• Misusing or improperly handling the tool, disregarding or deviating from the normal procedures or
the instructions and specifications for ViGOR equipment.
• Using the tool in combination with other products, tools, components or systems that are either
faulty, are determined to be the cause of a fault or are not intended for use with this product.
7. CE Conformity
Product description:
Type designation:
We declare that the designated product fulfills the regulations of the EU guideline
and DIN EN 1494.
Person authorised to compile the technical file: Sandra Müller, Tel.: +49 (0) 2191 792 319
Date: 26.04.2012
Hermann J. ZERVER
ViGOR GmbH • Am Langen Siepen 13 - 15 • 42857 Remscheid
info@vigor-equipment.com • www.vigor-equipment.com
Service jack
ViGOR V 2480; V 2481; V 2649
2006/42/EC
15