Maintenance And Cleaning - Vigor V 2480 Betriebsanleitung

• Do not make any changes to the jack.
• Use only original accessories and spare parts from the manufacturer.
• Disregarding these instructions may lead to personal injury or damage to property.
• Use only the lever supplied or an approved lever with this product.
• Using other levers may affect the functionality of this product. Ensure that all persons and/or tools are
located out of range of the load when lowering the load in order to prevent injuries.
• Opening and closing the valve too quickly may result in dangerous jerky movements.
• Overload may cause damage to the hydraulic system as well as personal injury.

3. Maintenance and cleaning

USE HIGH-QUALITY HYDRAULIC JACK OIL ONLY.
• Never use brake fluid, alcohol, glycerine, motor oil or turbine oil.
• Contaminated oil may affect the function of the jack and cause the load to drop suddenly.
Refilling the oil:
1. C ompletely lower the hydraulic arm, and then remove the oil filler plug.
2. P our in the oil until it reaches approx. 6.5 mm below the opening.
Replace the oil filler plug, ensuring that it has been tightly closed.
Changing the oil: (Change the oil at least once per year.)
1. C ompletely lower the hydraulic arm, and then remove the oil filler plug.
2. P lace the jack on its side and drain the oil out into a container.
Dispose of the oil as per the local legal provisions in force.
3. F ill the cylinder with a suitable hydraulic jack oil, such as Mobil DTE 13 or similar.
4. R eplace the oil filler plug, ensuring that it has been tightly closed.
Lubrication:
• Use a light lubricant for all moving parts in order to prevent the formation of rust.
Maintenance:
• When the jack is not in use, remove the lever rod.
• Always keep the castors, grips and lowering elements clean.
• If the jack is used daily, maintenance must be carried out on a quarterly basis, or every
1000 operating hours at the latest.
• Replace damaged or worn components and lubricate all moving parts.
• Only use spare parts recommended by the manufacturer, as any other parts will invalidate any express
or implied warranty.
• Ensure that the relevant environmental protection regulations are observed when disposing of individual
parts, lubricants and oils, etc.
• Use a cleaning spirit to clean the tool or its individual parts.
• Never clean with solvents or acids, esters (organic compounds comprising acids and alcohol), acetone
(ketone), chlorinated hydrocarbons or oils containing nitro hydrocarbons. Do not use any chemicals with
a low burning point.
• For customer service, contact your distributor or the manufacturer.
14