Denon DN-508MX Schnellanleitung Seite 12

•
Mute: Click one of these buttons to
mute either the music only (Music) or all
audio signals (All).
•
Ethernet: Use these controls to configure
your Ethernet settings. Click one of the
Mode buttons to set them to detect the
network settings automatically (Auto) or
to use the settings you enter yourself
(Manual). Click the IP Address, Subnet
Mask, Gateway, or IP Control Port
fields and enter the numbers for each
using your computer keyboard.
•
Baudrate: Click one of the buttons for
each port to set the baud rate of each
one. RS232C is for the remote port.
RS422 is for the RS-422 port. Each
rate is shown bits per second (BPS).
•
Time: Click each menu next to System
Time to set the current month, day, year,
hour, minute, and second. DN-508MX
will display this at the top of the web
interface and will use it for scheduling.
Click one of the Enable buttons to
enable (On) or disable (Off) daylight
saving time. When on, click each menu
below it to set the month, day, and hour
that daylight saving will start and end.
Click the Offset menu to select how
much the time will be shifted.
•
Password: Use these fields to set a
new password for the administrator
(Admin), which can control all DN-
508MX functions,
(Operator), which can control only
certain functions. Click each field and
enter the characters for your current
password (Old Password) and the new
password twice (New Password and
Confirm Password). Click Save to
save the new password.
•
Firmware: This field shows the DN-
508MX firmware file to upload, if any.
To upload a firmware file from your
computer to DN-508MX, click Browse,
and then find and select the file. After
that, click Verify to confirm the file is
valid. If it is valid, then click Execute to
update the firmware.
Important: Visit
download the latest firmware for DN-
508MX.
•
Information: This section shows the
current network addresses (as set in the
Ethernet section) and firmware version
(as set in the Firmware section).
12
or the operator
denonpro.com to