Werbung
Connections
Connecting the speaker cords to the speaker terminals
Black line
1. Remove the ending part of the vinyl covering from the cut.
2. Twist the tip of speaker cord and then insert it into the hole while
holding down the terminal lever.
● Do not reproduce sounds at so high a volume that they are distorted;
● When moving the speakers, do not pull the speaker cords;
● The speakers are not magnetically shielded. If it is located nearby
Press
Before connecting:
● Make sure to match the polarity (F and G)when connecting the
● Turn off the power to the amplifier before connecting the speaker
● The impedance of each speaker is 8 K. If this does not match with
● The maximum power handling capacity of the SP-F500 is 100 W.
● Be sure to turn down the volume level on the amplifier to prevent
● When using a microphone, do not aim it at the speakers or use it
● Before replacing the cartridge, always turn off the power both to the
Type
Speaker unit
Power Handling Capacity
Impedance
Frequency Range
Sound Pressure Level
Dimensions
Mass
Accessories
Check to be sure you have the above supplied accessories.
If any of the items above is missing, contact your dealer immediately.
Design and specifications subject to change without notice.
–3–
English
Precautions for installation and daily use
otherwise, the speakers may be damaged by internal heat buildup.
otherwise, the speakers may fall over, causing damage or injury.
the TV or monitor, it will probably cause color distortion on the
screen. To avoid this, place the speaker about 30 cm away from the
TV or monitor.
] When placing the speakers near a TV set, turn off the TV's main
power switch or unplug it before installing the speakers. Then
wait at least 30 minutes before turning on the TV's main power
switch again.
Some TVs may still be affected even though you have followed the
above. If this happens, move the speakers away from the TV.
Connecting the speaker system to the amplifier
speaker cords.
system; otherwise, the speakers may be damaged.
the speaker impedance range indicated on the amplifier, you cannot
connect this system to the amplifier.
Excessive input will result in abnormal noise and possible damage.
unwanted noise before performing following operations:
] Turning on or off other components
] Operating the amplifier
] Tuning FM stations
] Fast-forwarding a tape
] Continuously reproducing high frequency oscillation or high pitch
electronic sounds
] Connecting or disconnecting a microphone
near the speakers; otherwise, the howling which occurs may
damage the speakers.
amplifier and to the turntable; otherwise, the clicking noise may
damage the speakers.
Specification
: 3-way Bass-Reflex Type
Woofer
: 16.0 cm cone × 1
Midrange
: 10.5 cm cone × 1
Tweeter
: 2.5 cm dome × 1
: 100 W
: 8 K
: 35 Hz – 20 000 Hz
: 85 dB/W·m
: 210 mm × 822 mm × 252 mm
(W × H × D)
: 8.6 kg each
Speaker cords
: 4 m × 2
Werbung
