Safety Instructions - Klarstein Airakles Bedienungsanleitung

EN
18

SAFETY INSTRUCTIONS

• Check if the voltage indicated on the appliance corresponds to the local mains
voltage before you connect the appliance.
• To avoid a hazardous situation due to inadvertent resetting of the thermal cut-out,
never connect this appliance to a timer switch.
• Do not use the appliance if the mains cord, the plug or other parts are damaged.
• If the power cord is damaged, you must have it replaced by supplier, or a service
centre or similarly qualified persons in order to avoid a hazard.
• Never reach into the blender glass jug with your fingers or an object or open the
glass jug lid while the appliance is plugged in or operating. The cutting edges of the
blade unit are very sharp.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Never let the appliance operate unattended.
• Never use the glass jug to switch the appliance on and off.
• Do not touch the cutting edges of the blade units when you handle or clean them.
They are very sharp and you can easily cut your fingers on them
• If the blade unit gets stuck, unplug the appliance before you remove the ingredients
that block the blade unit.
• Never immerse the motor unit in water or any other liquid, nor rinse it under the tap.
Only use a moist cloth to clean the motor unit.
• Always unplug the appliance before you assemble, disassemble or make
adjustments to any of the parts.
• Food and liquid temperature cannot exceed 40 °C
• Do not exceed the maximum level (1.5L) indicated on the glass jug and the volume
mark in this manual.
• Never operate the blender with out food or liquid in the glass jar.
• Never operate the blender for more than 1 minute without interruption.
SAFETY FEATURES -- Thermal cut-out
• The appliance is equipped with a thermal cut-out that automatically cut off the
power supply to the appliance if it is overheating.
• If the appliance suddenly stops running:
1. Remove the plug from the wall socket.
2. Let the appliance cool down for 30 minutes.
3. Put the plug in the wall socket.
4. Switch on the appliance again.